Timbercote has been the go-to varnish system for many Marine Painters and DIY enthusiasts accross Australia, its gloss levels, excellent retention, durability and perfomance have proven to be among the best available in the country.
Produtc info
EXPERT TIPSWhen applying Timbercote it is advised to use multiple thin coats rather than a few thick ones; expect to use almost an equal quantity of
Thinner #45 (including cleaning up at the end of the day). The first two coats should require only half a day’s drying with a light sand between
coats. After that, allow a full day between coats and only very light flour paper (and only if required).
• Easy to use - Brush, roller or spray
• Proven performance over many years
• Specifically formulated for marine use
• Great flow and wet look finish
• Tough resin and high UV absorption
• Can be applied to teak after strict de-oiling
• Upgrading existing sound varnish finishes
• Interior and exterior
• Exterior beautification and protection of most timbers
• Can be applied over timber, sealed with Altex Epoxy Timber Sealer
• A Minimum of 5 coats is recommended for exterior exposure
• Is formulated to be applied at 30-40 microns dry
• Recommended that Timbercote be thinned up to 40% by volume with Altex Thinning Solvent #45 when used as a priming and sealing coat
• Theoretical coverage is 14.8m² per litre 30-40 microns dry, do not over build
• To accelerate cure and increase the hardness of the film, add Altex Regatta 2K Additive (refer product data sheet)
